-
Products
-
- Featured Products
- Supraflex Cruz
-
- Professionals
- Patients & Caregivers
- About SMT
Balloon material | Multi-layered polyamide |
Balloon fold | Tri-fold |
Hydrophilic coating | Selective hydrophilic coating at distal shaft including balloon tip |
Balloon diameter | 2.0 mm - 4.5 mm |
Balloon length | 9.0 mm - 30 mm |
Tip entry profile | 0.016"/0.41mm |
Shaft diameter | Proximal 1.73 F (2.00 mm - 2.75 mm), 2.01 F (3.00 mm - 4.50 mm) Distal 2.67 F(2.00 mm-3.75 mm), 2.9 F ( 4.00 mm & 4.50 mm) |
Catheter length | 138 cm |
Rapid exchange length | 25 cm |
Markers on the proximal shaft | 85 cm and 95 cm |
Maximum recommended guidewire | 0.014"/ 0.36 mm |
Guide catheter compatibility | 5F compatible |
KBT compatibility | 6F ≤3.50 mm diameter and all lengths |
Diameter (mm) |
Length (mm) | |||||
9 | 12 | 15 | 20 | 25 | 30 | |
2.00 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
2.25 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
2.50 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
2.75 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
3.00 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
3.50 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
4.00 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
4.50 | ✓ | ✓ | ✓ | ✓ | ✓ | ✓ |
* upto 3.5 mm diameter for all lengths.
NP = Nominal Pressure, RBP = Rated Burst Pressure, KBT = Kissing Balloon Technique
Disclaimer: This product is intended for use by or under the directions of a physician. Prior to use, refer to the "Instructions for use" supplied with the product for indications, contraindications, side effects, suggested procedure warnings and precautions. As part of our continuous product development policy we reserve the right to change product specifications without prior notification.Wilma SC is a trademark of Sahajanand Medical Technologies Limited. Bench test results may not necessarily be indicative of clinical performance. Test performed by and Data on file at Sahajanand Medical Technologies Limited. Testing performed on Wilma SC (2.50 mm x 15 mm). Information contained herein for distribution outside the USA, Japan & France only. Check the regulatory status of the device before distribution in areas where CE marking is not the regulation in force.